Description: The of the graphics card adopts three FP solid capacitors, which makes the more stable and . Connect the card with the 6PIN interface to strengthen the , so that the graphics card can be supplied from the main board independently, so as to reduce the burden on the main board when taking the card. The graphics card slot adopts the loading connector, which makes the graphics card contact -E connector adopts multi-layer shielding wire, which can be connected to without attenuating the signal. The wire is soft and easy to walk, so you want to put the graphics card in there. Slot with fixed card, convenient to remove the graphics card and fixed graphics card, make the card not fall off from th. The product applies: brand new design, 1X, 2X, 4X, 8X, 16X compatible (1-16x and 16-16x BOTH can use), the circuit board conversion line, , more efficient, more practical! Specification: Material: copper, PVC USB cable: 60cm/23.62in Package Includes: 1x -E 16X Adapter 1x -E 1X Riser Card 1x USB 3.0 Cable 1x Power Cable : 1. This extension is applicable to the mainboard slot (1 x, 2x, 4 x, 8 x, 16 x). Please the power cord for the floppy. When plug -E extension must be computer broken wires plug again. 2. The form a complete set of wire rod is , never grab line to 3. When plug wire must identify the direction, not to counter or offset, prevent burning equipment, plug wire when the socket of equipment first, then plug wire, avoid too hard plug socket pin is broken. 4. graphics Suggestions with the old line, the mainboard is 16 x also recommends using the