TWS connection method: Power on the two products, when Bluetooth is not connected, and the USB flash drive and AUX are not inserted! Press and hold the microphone volume adjustment knob of one of the products for more than 3 seconds, and the red TWS indicator light starts to flash, indicating that it is looking for a matching pair. After the pairing is successful, the TWS indicator of the product is always on, indicating the left channel, and the TWS indicator of the other product flashes for the right channel. After the pairing is successful, the pairing function can work normally in Bluetooth, USB flash drive, and AUX modes. TWS cancellation method: Press and hold the microphone volume adjustment knob of one of the products for more than 3 seconds, and the red indicator light goes out, indicating that the TWS function has been canceled TWS clear pairing record: After TWS pairing, the host and the slave will record each other, making it difficult for a third party to pair successfully after entering, and the code needs to be cleared once. Press and hold the music volume adjustment knob for more than 3 seconds to clear the pairing record Note: In TWS mode, only the host will emit the microphone sound; in TWS mode, due to limited resources, the USB flash drive will freeze when decoding FLAC and APE songs, and there is no such problem in non-TWS mode Product name: Isolated low-noise structure upgraded version of karaoke reverb board Product model: ZK-DAM H2 Input voltage: wide voltage 8-36VDC, no AC input Bluetooth chip: Mountain View BP1048B2, Bluetooth 5.0 Bluetooth decoding format: SBC, AAC Bluetooth distance:15 meters U disk decoding format:MP3, WAV, FLAC, APE, bit rate must be less than 1500kbps. Mic interface:dual 6.35mm microphone interface Power interface:DC5.5-2.1 female socket, or terminal