Coolant Funnel: The Innovative bleeding kit controls the coolant entering system and enables unattended Filling. Eliminates trapped air pockets which may cause instability in the cooling system and heater. Fill Securely Without Leaks: Highly sealed interface & clear funnel design, allows a quick visual check of the coolant. Take up the mess and save your time. Material & Fine Workmanship: Made of Plastic + Metal material. Test to withstand 200 degrees high temperature & accidental falls (Unless encounter a severe external force). Suitable for Most Vehicles: Multiple adapters, 2x45degree elbows & a 5inch extender, Fit Radiators or Surge Tanks on Most Domestic and Import Cars and Light Trucks. Economic Design: The Fluid Stopper will help you economically recycle unused coolant in the funnel after finish. Bright color and sealed lid help you to storage efficiently. Instructions: 1. Install the correct size adapter and Tight to make it doesn't leak. Place the gasket in a downward position. 2. YOUR CAR SHOULD BE OFF, DO NOT START THE CAR YET! Fill the coolant funnel about 1/3 up while COLD, so when system burps fluid falls into the system rather than more air. 3. Go to your car and set the climate controll settings (or heat setting) to the hot, but make that the fan/heater is "OFF". 4. Now START you car, let the car idle for a while until it's hot enough to open the thermostat and turn on the fans. After , and once the thermostat opens up to cool your engine you'll see the coolant level drop, and a few to a amount of air comming up, this is the trapped air escaping your cooling system. 5. After standard hour of running, if you still see air bubble comming out, check your overflow tank and make it has coolant in it. 6. When run the engine, fluid l should be at low position. Keep RPM on idle position. (Shut down the engine if notice the fluid level rise excessively. Wait for fluid level go lower before restarting the engine.) 7. Once the bubbling stopped, Use Fluid Stopper for remaining fluid inside the funnel 8. Finish Colour:black+yellow+transparent Material:Plastic + Metal Package Contents: 1 set x Spill Proof Coolant Filling Kit Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.