Features 1. Solves the issue of rapid turn signal flashing that may occur after installing LED lights. 2. Addresses fast flashing of turn signals and potential vehicle fault warnings caused by LED light installation. 3. Helps stabilize turn signal operation and prevents error alerts on vehicle systems when LED lights are installed. 4. Compatible with vehicles equipped with driving computer systems, including models such as Magotan and Mercedes. 5. High-quality construction with reliable performance. Specifications Material: Cement resistance Model: 20W Light source power: 21W Applicable models: Motorcycle, electric car Light source: LED Color temperature: 500K Service life: 4200 hours Package List 4 x Motorcycle LED Decoder Installation Notes The left and right turn signal circuits are not identical. If LED lights are installed on both left and right sides, a decoder must be installed for each side. If replacing lights front and rear, two decoders are required. However, front left and rear left turn signals (using one resistor) and front right and rear right turn signals (using one resistor) must be properly wired with resistance. For easier installation and optimal performance, it is recommended to install one decoder for each turn signal. Note 1. The resistor generates heat during operation. Do not mount the resistor directly on adhesive, fabric, or flammable materials. Install only on metal surfaces such as iron plates. 2. Maintain a gap of at least 1 cm between the resistor and any wiring. Direct contact may cause heat from the resistor to melt the wire insulation.