Description: Operating voltage: 4.5-5.5V (input) VCC: Connect the power supply positive GND: Connect the power supply negative Operating current: about 220mA (relay pull state) Static operating current: 8mA or so (relay release state) Receiver size: 65*56*22mm (with housing, housing with 3mm screw hole) Module type: 433MHz learning wireless access module Can learn the common 433MHz remote control (such as 2262 2260 2264 EV1527, etc.), stable performance, easy to operate Specification: Material: FR4 glass plate Size: Approx. 65*56*22mm / 2.56x2.20x0.87inch Receiving distance: between 15-1000 meters (can through the wall) Working mode: self-locking, jogging two kinds of work modules (four-way each road can be independently set to self-locking or jog) Scope of application: water pump, light bar, lamp, home appliances, machinery and equipment, mechanical switch, roll gate, shutter curtain, etc. Work instructions: D5 (power indicator), D1-D4 (relay switch indicator), D6 (learning indicator) (COM), normally closed (CB) (Note: normally closed and common in the normal state is connected, so that the output of the module is used as a switch; The switch is often used when the closed end is usually not used, only the normally open and common) First, learning methods: Press the learning button S1, immediately release, immediately press and hold S1 (faster), learning light D6 flash 1, and then release the S1 key; hold the need to learn the remote control button, learning instructions Light flash 2, to prove the first road to study success Other three way to learn the same way, 2 Road 3 Road 4, respectively, corresponding to the keys S2, S3, S4; Second, the wireless function to clear the method: Power off state, hold down S1-S4 any one learning button, and then power, learning light flashing 4, the release button that the module 4-way all clear the success Third, Self-locking and jogging function conversion instructions (4-way each is set independently, the same way) Jog: power state, press and hold the learning button after the power, learning indicator D6 flash 2, the release button, this time set to jog output. Self-locking: power state, press the learning button after power, learning indicator D6 flash 3, the release button, this time set to self-locking lock output. Package Includes: 1x Wireless Switch Module 1x Remote controller