Features 1、The measurement circuit is isolated from the incoming signal. Hall‑type current conversion can withstand 30 times the nominal input, prevents instantaneous high current access and burns out the internal components of the sensor 2、The product can isolate the detection signal and the output signal, effectively filter the noise in the signal, greatly improve the signal‑to‑noise ratio and signal stability of the product, and effectively enhance the product's anti‑interference ability 3、The primary and secondary sides of the hole current transmitter are highly insulated and isolated, possess high accuracy, small size, low power consumption, wide frequency response, and anti‑interference characteristics 4、Perforated input, no insertion loss, fixed with standard guide rail and flat screws, convenient to install 5、Suitable for generators, motors, intelligent low‑voltage power distribution cabinets, air conditioners, fans, street lamps, power grid monitoring, motor signal monitoring, railway system signal monitoring industries and other load current intelligent monitoring systems Specification Item Type: AC Current Transmitter Material: ABS Power Supply: DC24V Installation Method: Standard rail + flat screw fixation Product Use: Used to measure AC current, especially for power frequency 50Hz sine wave AC current Rated Current: AC0-50A Rated Output: DC4-20mA Accuracy: 0.5% Overload Capacity: 30 Times the nominal input Temperature Drift: ≤500PPM/℃ Linearity: 0.1% Frequency Bandwidth: 20-5KHz Current Consumption: <15mA+ output current Response Time: <200ms Working Temperature: -109℃~+70℃ Storage Temperature: 25℃~85℃ Package List 1 x AC Current Transmitter