Aluminum Cooling Fan Heat Sink for VXL 3S ESC Suitable for Traxxas RC Models 2WD 4X4 Vehicles Installation:1.To install the cooling fan,press the fan tabs over the VXL-3S heat sink until they snap on.<br> 2.Plug the VXL-3S cooling fan connector into the plug on the front of the cooling fan.<br> Notes:<br> 1.The fan must blow air down across the flns.Be sure the "V" decal up.<br> 2.The fan plug should face the front of the VXL-3S<br> 3.The fan is not water resistant.<br> 4.Always turn off the VXL-3S and unplug the model battery when not in use<br> 5.Periodically removethe fan and clean and debris from the fan and the heat sink<br> Suit For:<br> for Hoss VXL<br> for 4-Tec 2.0 VXL Chassis<br> for Bandit VXL<br> for Drag Slash<br> for Fiesta ST<br> for VXL<br> for VXL<br> for Slash<br> for Slash Ultimate<br> for Slash VXL<br> for Slash<br> for Slash VXL<br> for Stampede VXL<br> for Stampede VXL<br> Colour:blue<br> Material:plastic<br> Package Contents:<br> 2 x RC Car Cooling Fan<br> Only the above package content, other products are not included.<br> Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.