CC2531 Zigbee Emulator CC Debugger USB Programmer CC2531 Sniffer Outputs 8 IO ports Debug pins Combined firmware to achieve analysis function The DC debugger is a small programmer and debugger for the low-power RF system. It can be used with the integrated IAR workbench for 8051 (version 7.51A or later) for debugging and SmartRF Flash programmer for flash programming. The DC debugger can also be used to control SmartRF Studio devices. Table of contents: DC debugger 10-pin flat cable with 2.54mm connector The DC debugger can be used to and debug the following systems based on 8051: CC1110...CC1111 CC2430...CC2431 CC2510...CC2511 CC2530...CC2531...CC2533 CC2543...CC2544...CC2545 It is possible to control the same devices from SmartRF Studio. Additionally, the CC-Debugger can control the following SmartRF Studio transmitters: CC1120...CC1121...CC1125...CC1175 CC1100...CC1101...CC110L...CC113L...CC115L CC2500...CC2520 It can also be used for PurePath wireless devices: CC8520...CC8521 CC8530...CC8531 The DC debugger works with IAR EW8051 version 7.51A or later Product Introduction: Operating Frequency: 2.405-2.485GHz Wireless Transmission Rate: 250Kbaud Power Consumption: Less than 20mA (receiving); Less than 25mA (transmitting) Color: Black Material: Plastic Package Contents: 1 x CC2531 Sniffer Board with Antenna 1 x Programmer Download Cable 1 X CC Debugger Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture to be slightly different from the real thing. The allowable measurement error is +/- 1-3 cm.