DC 12V/48V BLDC 6-60V 400W/3 Phase Brushless Motor Controller Driver-Board Features: Note:This driver is a DC 3-phase brushless control board,which requires the motor to have Hall to work properly This driver is only suitable for DC brushless motors with 120° electric angle and hall BLDC wide voltage 6-60V,high power 400W DC three-phase brushless with Hall controller,support PLC 0-5V analog control Support PWM control Type 2.5-5V Interface using terminal standard heat sink board integrated speed potentiometer to the hands of the power can be used to save time and effort Specification: Product Name:400W brushless DC motor driver with Hall Operating voltage:6~60V Maximum current:rated 16A,peak 20A Maximum power:400W Overcurrent protection:Yes Product size:about 63*45*31MM Product weight:about 77g Package includes: 1*400W Brushless DC Motor Driver with Hall Note: Only include the above package products Specifications are manually tested and are for reference only Please allow 0-1cm error due to manual measurement Please make sure you don't mind before bidding Due to the difference between different monitors Pictures may not reflect the actual color of the item.Thanks 1.There is no fuse in the power supply circuit on the motherboard,so it is recommended that you add your own fuse and reverse the positive and negative terminals of the power supply Reversing the positive and negative terminals of the power supply can cause permanent damage to some of the chips on the board(even at high current for a few seconds) 2.Sampling overcurrent protection at motor output during normal operation Due to the power of the module The current is very large,please do not artificially short-circuit the module when it is not working properly But a short-circuit has burned the line burst tube may, the first wiring test machine,please use a small current and low voltage test To be OK,in the high current and high voltage,due to the bare board module for sale,pay attention to the insulation of the wiring wire,is strictly prohibited strong voltage touches the board parts 3.Do not connect the obvious and drive module voltage,current,power phase does not match or far from the motor,to avoid inexplicable damage