With a wide input voltage range from 6V to 40V DC, the step-down converter accurately adjusts output voltage and current. Efficiency can reach up to 95% when converting 24V to 12V at 20A. Features a 75V/80A dual MOSFET design. Input and output use high-frequency, low-resistance electrolytic capacitors for low ripple and stable output. Equipped with 30A screw terminals for convenient wiring. Includes two heat sinks to enhance thermal dissipation. When the difference between input and output voltage is large, reduce power and current accordingly. Input Voltage: 6V–40V DC (10V–40V recommended) Output Voltage: 1.2V–36V DC Output Current: Up to 20A (15A recommended) Output Ripple: ≤50mV Wiring Method: Terminal Short Circuit Protection: Self-recovering (not intended for prolonged short-circuit conditions) Dimensions: 60 × 53 × 27 mm (2.36 × 2.08 × 1.06 inches) Terminals: VO+: Output positive VO-: Output negative +IN: Input positive -IN: Input negative CV: Output voltage adjustment CC: Output current adjustment EN: Enable control — low level disables output; high level enables output When input and output share a common ground, the module operates in constant voltage (CV) mode under no-load conditions and constant current (CC) mode under load. Color: As shown Material: PC + Metal Package Includes: 1 × 300W 20A Step-Down Buck Converter Note: Color may vary slightly due to lighting and display differences. Dimensional tolerance: ±1–3 mm.