Simply connect the motherboard of the UPA programmer directly or using a DB9 male/female extension cable (1:1). Insert the correct configuration key into the slot on the main board and start programming via ZIF or DIP female socket. You can also use the included DIL-to-10-pin flat ribbon adapter, place it inside the ZIF socket, and connect a clip or clamps for ISP programming. For Motorola MCUs: Choose the appropriate adapter, connect the flat cable (PIN1 is clearly marked on both the cable and the adapter, as well as on the 10-pin ISP connector on the main board). Select the VCC supply source using the jumper bridge next to the ISP connector on the main board (ON = powered by UPA; OFF = target provides its own power). Slide the adapter over the soldered PLCC MCU on the target PCB — no soldering, no pinout verification, no manual pin counting, saving time and reducing errors. Compatible microcontrollers include: STMicroelectronics: ST62-40/45/49 National Semiconductor: CR16-HCS5(9)/MCS5(9)/MES5(9)/MFS5(9)/MCT5(9)/HCT5(9) Microchip: PIC12F-508/509/629/675; PIC16F-627(A)/628(A)/648A/72/73/74/76/77/818/819/83/84(A)/870/871/872/873(A)/874(A)/876(A)/877(A) Motorola: MC68HC05-B6/B8/B16/B32/E6/E6/H12/L28/P3/P3*/X16/X32; MC68HC08AS20/AS32/AS60/AZ32/(9)08AZ32A/908AZ60/908AZ60A; MC68HC11/A1/A8/E9/EA9/E20/F1/K4/KA2/KA4/KG4/KS2/KS8/L6/P2/PA8/PH8; MC68HC912-B32/BE32/D60/D60A/DC128A/DG128/DG128A; MC9S12-D64/A128/DG128/DG256/H128/H256 Atmel 8051 Architecture: AT89S-51/52/53/8252/8253 Atmel AVR 8-bit: AT90S-1200/2313/232/2333/2343/4433/4434/8515/8535; ATmega-8/16/161/162/163/323/64/103/128; ATtiny-12/15/2313 EEPROMs: 24C-01/02/04/08/16/32/64/65/128/256/512; 85C-72/82/92; MCM2814; PCA8581; PCF85-81/82/94/98/102/116; SDA25-16/26