Generator Controller with LCD Display DC 8‑35V Generator Set Controller for HQM6110U Gasoline Generator Sets Item Type: HQM6110U Generator Controller Weight: 717g/25.3oz Material: Plastic Product Size: 20 x 15.5 x 4.7cm/7.87 x 6.1 x 1.85in Applicable Model: For HQM6110U Application: diesel generator set Alternator Frequency: 50Hz 60Hz Power Consumption: < 3W(standby ≤2W) Three Phase Four Wire 15V AC-360 V AC (ph N) Three Phase Three Wire 30V AC-620 V AC (ph ph) Single Phase Two Wire 15V AC-360 V AC (ph N) Two Phase Three Wire 15V AC-360 V AC (ph N) Speed Sensor Frequency: Maximum 10000Hz Starting Relay Output: 16A DC28V DC supply output Fuel Relay Output: 16A DC28V DC supply output Programmable Relay Output 1:7A DC28V DC supply output Programmable Relay Output 2:7A AC250V passive output Programmable Relay Output 3:16A AC250V passive output Programmable Relay Output 4: 16A AC250V passive output Current Transformer Secondary Current: Rated :5A Working Conditions: Temperature: -25~70°C Relative humidity: 20~93%RH Storage Conditions: Temperature: -30~80°C Protection Level: IP65 When a waterproof rubber ring is installed between the controller and the control panel. Key Description: Stop, Reset Key: In both manual and automatic mode, the operating generator set can be stopped. In the generator alarm state, any shutdown alarm can be reset. In the shutdown mode, press this key for more than 3s to test whether the panel indicator is normal (test light). During the shutdown process, press this key again to stop the machine quickly. Power Button: In manual mode, press this key to start the stationary generator set, press this key during the startup of the unit, the unit state will jump to the next state. Manual: Press this key to put the controller into manual mode. Auto Key: Press this key to put the controller into auto mode. Switch On and Off Key: In manual mode, press this key to control switch on and off. Flip Up, Add: Flip the screen to move the cursor up or add the number of the cursor in the parameter setting. Scroll Down, Reduce: Scroll down the screen to move the cursor down or reduce the number of the cursor in the parameter setting.