1、The preheating time of the laminator needs 3-5 minutes to complete, the laminating speed canbe 300mm/min with low noise and fast heat dissipation, and high efficiency. 2、Over-plastic thickness is about 0.6mm, suitable for A3 or smaller size. 3、Constant temperature over-plastic smoothing (preheating is divided into 80 degrees and 125 degrees, the middle is the cooling gear; after the switch is turned on, the red light is on, and the switch is turned to the right to 80 degrees, the green light is 80 degrees. It can be plastic-sealed when it is on; similarly, the switch should be turned to 125 degrees to the left. When the temperature reaches 125 degrees, the green light will be on before plastic-sealing). 4、If the position of the file is deviated or the power is off, immediately push the out-of-shift push button to save the file 5、There is a scale gauge at the film inlet, which can measure the documents to be over-plasticized, so as to choose the specifications of the film reasonably. 6、The width of the film inlet is 340/235mm, and the size of A4 is easy to pass; the speed of the film exit is 300mm, and the thickness of the glue is 80-125mic. Item Type: Cold laminator Specifications: EU Plug 220V Power: 410W Over-Plastic Width: Approx. 330mm / 13in (A3 format) Over-Plastic Thickness: ≤0.6mm / 0.02in Over-Plastic Speed: 300mm/minProduct Size: Approx. 420 x 120 x 75mm / 16.5 x 4.7 x 3in 1 x Laminator 1 x Bracket