Microdermabrasion Beauty Machine Household Skin Care Vacuum Suction Dermabrasion Machine (100‑240V) US Plug Item Type: Microdermabrasion Machine Material: ABS, Metal Operation Instructions: 1. Please connect all accessories to the machine first. 1) Unscrew the vacuum connector, making sure there is a large cotton filter in the center and a large black ring around the connector head. 2) Tighten the connector after checking. Then connect the PVC hose to the connector. 3) Put the other end of the PVC hose into one end of the wand. 4) Put a small cotton filter on the wand head. (Look, there's a small black ring around the head) 5) Screw the microdermabrasion head into the microdermabrasion handle (select the appropriate size) 3. Slowly adjust the vacuum strength, from minimum to maximum, the vacuum gauge will display pressure data. In general, do not set the strength to maximum unless necessary. 4. Treatment schedule and frequency of treatment (see paper manual) 5. Place the microdermabrasion tip on the surface of the skin (starting from the forehead) and glide slowly. Don't let the microdermabrasion tip stay in one spot for too long as this can damage your skin. 6. Gently stretch the skin with your thumb and other fingers and slide the handle 2-3 times over treatment area. Then cross in different directions to prevent streak lines. Brush strokes or polishing actions can be used in different locations. 7. After treatment, use a soft hair brush to remove any remaining dead skin and rinse with a damp sponge or cool damp towel. 8. Allow skin to dry, then use desired skin product. 9. When cleaning the microdermabrasion head, use a toothbrush or a cotton swab dipped in a small amount of ethanol to wipe off the dirty impurities, then clean with a UV lamp or high temperature.