Feature 1WATER FLOW CONTROL TEMPERATURE: The temperature can be controlled by the size of water flow. Large water flow has low temperature and small water flow has high temperature. 2INSTANT HEATING: The water heater is small in size, fast and efficient in heating, no need to wait for a long time. 3WIDE USAGE: Suitable for kitchen, bathroom, shower, etc. place for ordinary hand washing, dishes washing, face washing, bathing. 4TEMPERATURE UNIT SWITCHING: The temperature range is between 20 to 50, and the mode switching of Fahrenheit and Celsius can be set. 5SIMPLE INSTALLATION: The mini electric hot water heater is easy to install, saves space, convenient to use, with stable performance.SpecificationItem Type: Mini Electric Water HeaterMaterial: ABS, BrassHeating Body Material: Stainless SteelVoltage: 220V EU StandardPower: 3500WFrequency: 50-60HZWire: 1.5mm Temperature Range: 20-50Weight: Approx. 1100g/38.8ozInstallation Environment Requirements: 1. For kitchen, bathroom, toilet, shower room2. Electric wire shall be more than 2.5mm3. The circuit breaker switch needs to greater than 32A .wang-edit-text{ font-family:'Arial' !important; } .wang-edit-text table { border-top: 1px solid #000; border-left: 1px solid #000; } .wang-edit-text table td, .wang-edit-text table th { border-bottom: 1px solid #000; border-right: 1px solid #000; padding: 3px 5px; } .wang-edit-text table th { text-align: center; }Package List1 x Mini Electric Water Heater2 x Screw2 x Screw Anchor1 x User ManualNoteCommon Faults And Handling Methods:1. Check whether the power supply is normally powered on. The indicator light on the display will show the temperature when it is powered on, and will not light up if it is not powered on.2. Under normal power on condition, turn on the water flow, press the switch key, the machine starts heating, the water heater displays: outlet water temperature.3. If the temperature does not rise, there are two possibilities: one is that the temperature control switch (overheat protection switch) inside the water heater jumps, press the temperature control switch once to recover. The other is the heating pipe failure, replace to use.4. If there is a display that does not heat up, and the display lamp turns around, it means that the water flowing does not pass through the water heater, or the water pressure is too low, or the installation direction is wrong. Pay attention to the correct installation of water inlet and outlet. But if it also does not heat up when the water pressure is enough and there is water flowing, check the turbine at the water inlet of the water heater. It may be that something dirty is blocking the turbine, causing the water heater to not start.5. It is recommended that the length of the water outlet pipe of the water heater should not exceed 3 meter. If exceeds, there may be water pressure difference. If the water pressure is not enough, the water can not be started. (If the water tower is used in rural areas, the height of the water tower is required to be higher than 10m to make the water pressure achieve the starting value.)6. The display screen shows E1 overtemperature, E3 E4 or temperature sensor failure. First cut off the power, pass the machine through with cold water, and then power on again to use. Pay attention to the use of water flow not too small.7. The heating tube fault displays E2, the heating tube needs to be replaced.