The Mosky Third Space Bass Station is a 0-watt stereo bass amp pedal that fits pedalboards, replacing full amp signal chains with analog realism-powered by mic'd cabinet simulation, dual FX loops, parallel signal routing, and an SVT®-based preamp. Amp Preamp, Flexible EQ: ±15dB per band (Lows: 80Hz, Highs: 3.5kHz, Mids: switchable 400/900/1500Hz), Gain control: Clean/tight at low settings, authentic SVT growl/grunt above 70%, Level knob: Adjusts preamp master volume Parallel Signal Chain, Separates input signal (bypasses preamp) with 3-way switchable LPF (100Hz/Off/500Hz), Blend clean parallel signal with preamp tone: Retains low-end & dynamics even with preamp overdrive Versatile Cabinet Simulation, Cab Size Options: 4x10 Vented (open/wide range), 8x10 Sealed (tight/punchy lows), 1x15 Vented (warm mids/thick lows), Speaker Color Modes: Bright (aluminum cone bite), Modern (flat + extended highs/lows), Warm (vintage mid clarity). Adjustments: Mic Position (high-end roll-off), Resonance (cab low-end), Cabsim Blend knob: Mixes cab sim in/out of main signal Connectivity, Input: 1x instrument jack (1 Meg Ohm impedance) FX Loops: Dual (Parallel FX Send/Return + Preamp FX Send/Return) Outputs: TRS Out (main signal/bypass, 100 Ohm), DI Out (balanced main signal, 120 Ohm), DI Parallel (only parallel signal) Aux In (for mp3/phone, stereo to headphone out, no main output feed) Headphone Out (120mW @ 32 Ohm, with level control) Switches: Phase Control (prevents signal cancellation), GND Lift (reduces hum), Active/Passive (6dB boost for low-signal basses) Power: 9V DC (center negative), 50-100mA (100mA when headphone out is used) Dimensions: 120mm (W) x 75mm (H) x 65mm (D) Weight: 424g Color: As Shown Material: Metal Package Contents: 1 * Bass Optical Compressor