Bike Computer Mount (integrated Handlebars). Weight:106g (3.70z). Dimensions:187x39x33mm (7.4x1.5x1.3inch). Select M5 bolts or bolts according to the screw hole size ofthe bike. How to use Bike Computer Mount (ntegrated Handlebars) Select a Computer Mount according to your model, theninstall onto the Bike Computer Mount, and tighten the screwswith a 2mm Hex Wrench. Tips: There are 2 mounting directions for a Computer Mount, which can be installed on demand.<br><br>Install the Bike Computer Mount to the front of the bike andtighten the bolts with a 4mm Hex wrench. Notes: Select M5 bolts or bolts according to the screw hole sizeof the bike. The spacing between the screw holes of the Bike ComputerMount is 9-55 mm. Adjust the Bike Computer Mount to thefront or rear positions on the handlebars according to the sizeof the Bike Computer. When tightening bolts, 5Nm is recommended, or accordingto the recommended locking force value of the handlebars, that the two bolts are both locked on the BikeComputer Mount. lf there is only one bolt on the handlebar, orthe screw spacing is not sufficient for the installation of theBike Computer Mount, do not use this part, as this may causethe mount to fall. Install the camera (or accessories such as a flashlight) on the1/4inch screw or three connector of the Bike ComputerMount. Notes: lf installed on the 1/4inch screw, it is recommended to use awrench to lock the mount firmly during installation. lf the three- connector becomes loose afterinstallation, attach Anti-Slip Rings to the connector forreinforcement. The angle of the three connector can be adjusted afterloosening the screws on the base. Install the Bike Computer on the Computer Mount colour: Black Material: Aluminum Alloy + Plastic + Stainless Steel<br><br>Package Contents: 1 * Stand body 1 set * accessories<br><br>Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.