Features: Watchy is an E-Paper watch with open source hardware and software. It has a barebones design utilizing the PCB as the watch body, allowing it to be worn as-is, or further customized with different 3D printed cases and watch straps. It is a wearable development platform. Watchy's E-Paper display delivers a beautiful crisp image clearly visible under bright sunlight, Ultra-low-power e-paper 1.54 INCH display, a At 200x200 pixels and monochrome, the display offers a distinctive aesthetic. Watchy has both WiFi & Bluetooth LE connectivity, allowing it to connect with internet APIs (e.g. Weather, News, Traffic, Maps, Spotify, etc.), as well as Bluetooth enabled devices. We chose the ESP32 for its large community and support for a wide variety of development options (for Arduino, Micropython, ESP-IDF, Zephyr-RTOS, etc.) Specification: 1.3-axis accelerometer with gesture detection 2.Real-time clock for accurate time keeping with calendar and alarm functions 3.Built-in USB-to-serial adapter for programming on the go 4.Vibration motor for alerts 5.Four tactile buttons 6.Special Note: Be sure to select hardware version V2.0 when rooting. 7.Note: Not waterproof Note: 1. Click Set Wifi in the watch main menu. 2. Connect to the "Watchy Ap" wifi from another device, such as a mobile phone or computer/laptop. 3. Open 192.168.4.1 in your browser. On an iPhon, this page opens on its own when connected to wifi. 4. Click on "Configure WiFi" 5. Enter the SSID and password. (Note: SSID can be pre-filled through the network listed at the top of this screen) 6. Click the "Save" button and wait for Watchy. Seven. If the connection fails, the watch will display "Setup failed and timed out!" Otherwise, the local IP address and SSID of the connected network are displayed and confirmed.<